Choosing a tip for your coating
· Airless Sprayer
The tip decides the finish more than the machine does. Get the tip right and most spraying problems disappear.
Reading a tip number
Most tips use three digits, for example 517. Double the first digit for the fan width in inches at about 30 cm from the surface (5 means about a 10 inch fan). The last two digits are the orifice size in thousandths of an inch (17 means 0.017 in). Bigger orifice, more paint.
Matching the coating
The coating maker's data sheet, under "Application", names a tip range. Typical ranges:
- Stains and clear sealers: about 0.011 to 0.015 in.
- Lacquers and enamels: about 0.011 to 0.015 in, fine-finish tips.
- Interior and exterior latex: about 0.015 to 0.019 in.
- Heavy latex and primers: about 0.019 to 0.023 in.
- Elastomerics and block filler: about 0.025 to 0.035 in and up, which needs a larger machine.
Stay inside the machine
Every machine publishes a maximum tip. Running a bigger tip than that will not hold pressure and the pattern will "tail". Published maximum tips: LF19 0.019 in, A3 0.023 in, EP270 0.025 in.
Worn tips
Tips wear. A worn tip sprays a narrower fan with heavier edges and uses more paint. Many painters replace a tip after roughly 40 to 50 gallons of latex; check your fan width against a new tip.
Graco and Titan tips
Compatibility of HVBAN guns and guards with Graco and Titan tips is being confirmed with the manufacturer. Until then, use HVBAN tips.