Spraying a fence or deck
· Airless Sprayer
Fences and decks are where an airless sprayer pays for itself: hundreds of boards, gaps and edges that take days with a brush.
Before you start
- Clean and dry the wood. Most stains want two dry days before and after; read the can.
- Check the forecast for wind. Pick a calm morning.
- Cover plants, the house wall, windows and anything parked nearby. Move the car further than you think.
- Tell the neighbours if their side is close.
Tip and coating
- Semi-transparent and clear stains: a small tip, about 0.011 to 0.015 in.
- Solid stains and fence paint: about 0.015 to 0.019 in.
- A narrow fan (for example a 2xx or 3xx tip) is easier on pickets; a wider fan suits deck boards and solid panels.
Always follow the tip and thinning advice on the can. See choosing a tip.
Technique
- Practise on a scrap board until the edges of the fan are clean.
- Spray a few boards at a time, top to bottom, keeping the gun moving and about 30 cm away.
- On decks and rough wood, back-brush or back-roll while it is wet. It works stain into the grain and evens the finish.
- Do the deck last and work toward the exit.
Which machine
For a home fence and deck, the LF19 or A3. Long runs of commercial fencing are EP270 work.
Photo: illustrative scene, not a customer photograph.